FS: Toyota Stuff

[Mark]

I've been clearing out some of the various Toyota parts I've accumulated over the last few years that aren't of much use to me. They may be to others:
- 4AGE small port head and front wheel drive manifold.
- 4AGE large port head and rear wheel drive manifold.
Both heads have springs and valves but no shims or cams.
- One set of 4AGE camshafts. Either 240 or 244 deg. duration cams, stock lift.
- Two 4AGE stock computers.
- 1 13" tyre tube.
- 1 set of 2" RPM harnesses.
- 1 4.33:1 Open diff centre...fully functional. I think this would fit any 6.7" Toyota diff. Probably a good idea to check the spline count though.
- 1 4AGE oil cooler and fitting (between oil filter and block) - just needs pipes - only fits FWD model or MR2 model due to engine mounts getting in the way on RWD application.

Oh, and I've got 6 14"s mags for Toyota/Datsun/Mitsubishi RWD stud patterns off a Toyota Celica.

E-mail/PM me for prices for this paperweights...

Mark

[Spac]

If you get to the point where you're going to throw out the stock ECUs lemme know and I'll buy you a four-pack for 'em (so I can do nerdy electronics things).

And I wouldn't mind checking out the oil cooler stuff too.

[raybak]

Spac, I have a couple of Daihatsu ECU's you might be able to have a look at.

Ray

[takai]

Ill be taking the smallport head, oil cooler and possibly the diff.
Although i think 6.7 is S series not T series.

[Mark]

Oops, forgot to mention that everything has been sold including Diff and RWD Manifold to Michael and Ben in Sydney respectively. Takai, check your e-mail on the stuff I put aside for you.

I think I've got one set of small port cams left (240deg. duration) and that's pretty much it. Have to check...

Mark